控制升降貨梯液壓油污染我們需要注意什么?
1、控制升降貨梯液壓油的工作溫度,液壓油工作溫度過高對液壓系統的工作元件不利,同時會使液壓油加速氧化。一般機械液壓系統的工作溫度控制在65℃以下,工程機械液壓系統工作溫度以控制在80℃以下??刂埔簤河偷墓ぷ鳒囟戎饕菍?duì)液壓系統的冷卻器性能的控制,整個液壓系統液壓油油量的合理控制,液壓系統元器件負荷及轉速的控制。
1. Control the working temperature of the hydraulic oil of the lifting cargo elevator. Too high working temperature of the hydraulic oil is harmful to the working elements of the hydraulic system, and will accelerate the oxidation of the hydraulic oil. The working temperature of the hydraulic system of general machinery is controlled below 65 ℃, and the working temperature of the hydraulic system of construction machinery is controlled below 80 ℃. The control of the working temperature of hydraulic oil mainly refers to the control of the cooler performance of the hydraulic system, the reasonable control of the hydraulic oil quantity of the whole hydraulic system, and the control of the load and speed of the components of the hydraulic system.
2、升降貨梯元件和系統在加工和裝配過程中進行清潔,元件在加工制造中,每一工序都必須對加工中殘留的污染物進行凈化;元件裝配前必須進行清潔處理,裝配后必須進行嚴格的清潔和檢驗;油箱和管道在去除毛刺、焊渣等污染物后,需進行酸洗以去除其表面氧化物;對初裝好的液壓系統作循環沖洗,并定時從系統中取樣分析,循環沖洗直系統清潔達到要求。
2. The elevator components and systems shall be cleaned during the processing and assembly process. During the processing and manufacturing of components, each process must purify and remove the residual pollutants in the processing; Components must be cleaned before assembly, and strictly cleaned and inspected after assembly; After removing pollutants such as burr and welding slag, oil tank and pipeline shall be pickled to remove surface oxides; Carry out circulating flushing for the initially installed hydraulic system, and regularly take samples from the system for analysis until the system is cleaned to meet the requirements.
3、防止升降貨梯污染物混入液壓系統,油箱要合理密封并裝設能的空氣濾清器以防止塵土、水分的進入;注入新油必須經過有效的過濾,系統的回油也應進行有效的過濾;管路接頭等連接處密封嚴密,防止塵土、水分和空氣進入液壓系統;活動件必須裝有防塵密封裝置。
3. To prevent the pollutants from the elevator from entering the hydraulic system, the oil tank should be properly sealed and equipped with a high efficiency air filter to prevent the entry of dust and water; The new oil must be filtered effectively, and the return oil of the system should also be filtered effectively; The joints of pipeline joints and other parts shall be tightly sealed to prevent dust, moisture and air from entering the hydraulic system; The moving parts must be equipped with dustproof sealing device.
4、升降貨梯液壓油的過濾和凈化,液壓油過濾器是液壓系統中控制油液污染的重要元件,濾油器的應用必須保證過濾精度符合系統的使用要求,由流體阻力引起的壓力損失應盡可能小,并應具有足夠的油垢容量;定時對濾油器進行檢查和凈化。液壓系統油液的污染度隨著外界污染顆粒侵入率和系統內各種磨損顆粒數的增加而增大,隨著過濾比的增大而減小,因此合理選擇過濾比可有效地降低系統的污染度。固體顆粒是工程機械液壓系統污染的主要來源,通過合理選擇濾油器的過濾比是控制系統污染的主要措施。
4. For the filtration and purification of the hydraulic oil of the elevator, the hydraulic oil filter is an important element in the hydraulic system to control the oil pollution. The application of the oil filter must ensure that the filtration accuracy meets the requirements of the system. The pressure loss caused by the fluid resistance should be as small as possible and should have sufficient oil scale capacity; Regularly inspect and purify the oil filter. The pollution degree of the hydraulic system oil increases with the increase of the invasion rate of external pollution particles and the number of various wear particles in the system, and decreases with the increase of the filtration ratio. Therefore, a reasonable selection of filtration ratio can effectively reduce the pollution degree of the system. Solid particles are the main source of pollution in the hydraulic system of construction machinery, and the main measure to control the system pollution is to reasonably select the filter ratio of the oil filter.
5、定期檢查和更換升降貨梯液壓油,液壓油在使用過程中,污染物的侵入會對液壓系統造成不良的影響,要對液壓油污染進行有效的控制,必須定期對各密封處、接頭處進行檢查處理,對液壓系統的液壓油進行檢查分析,還要定期更換液壓油。更換液壓油時必須將舊液壓油放凈,整個液壓系統必須先清潔后,再注入新的液壓油。
5. Regularly check and replace the hydraulic oil of the elevator. During the use of the hydraulic oil, the invasion of pollutants will have a negative impact on the hydraulic system. To effectively control the hydraulic oil pollution, it is necessary to regularly check and handle the seals and joints, check and analyze the hydraulic oil of the hydraulic system, and regularly replace the hydraulic oil. The old hydraulic oil must be drained when replacing the hydraulic oil. The entire hydraulic system must be cleaned before injecting new hydraulic oil.
以上的精彩內容由電動液壓貨梯進行閱讀,想要知道更多有用的知識,歡迎點擊:http://shyulang.cn。
The above wonderful contents are recommended for reading by the electro-hydraulic cargo elevator. If you want to know more useful knowledge, please click: http://shyulang.cn 。
產品
資訊
- 2023-07-19 升降貨梯的控制開關怎么裝線
- 2023-06-29 電動液壓貨梯使用特點
- 2023-06-27 升降機的生產標準有哪些?
- 2023-06-21 升降機的用途和應用范疇有哪些?
- 2023-06-19 液壓升降機的使用維護方式
- 2023-06-13 導軌式升降平臺有哪些使用功能?
- 2023-06-10 導軌式升降機的裝置及使用
- 2023-06-08 家用別墅電梯的使用指南曳引式電梯